(To network interface card). (To hub).
|
Проектирование и Согласование любых объектов в Киеве |
|
http://kiev-security.org.ua
Wiring scheme: EIA/TIA 568B
This cable will work with 10Base-T, 100Base-TX and 1000Base-T and is used to connect a network interface card to a hub or network outlet. These cables are sometimes called "whips".
Note: While 10BaseT and 100Base-TX only uses two pairs, please do connect all pairs since 1000BaseT uses all of them, and save yourself some future debugging :)
(To network interface card).
(To hub).
RJ45 MALE CONNECTOR to network interface card).
RJ45 MALE CONNECTOR to hub).
| Name | Pin | Cable Color | Pin | Name |
|---|---|---|---|---|
| TX+ | 1 | White/Orange | 1 | TX+ |
| TX- | 2 | Orange | 2 | TX- |
| RX+ | 3 | White/Green | 3 | RX+ |
| 4 | Blue | 4 | ||
| 5 | White/Blue | 5 | ||
| RX- | 6 | Green | 6 | RX- |
| 7 | White/Brown | 7 | ||
| 8 | Brown | 8 |
Note: It's important that each pair is kept as a pair. TX+ & TX- must be in the pair, and RX+ & RX- must together in another pair. (Just as the table above shows).
Just for your information, this is how the pairs are named:
| Pair | Pins | Common color |
|---|---|---|
| 1 | 4 & 5 | Blue |
| 2 | 1 & 2 | Orange |
| 3 | 3 & 6 | Green |
| 4 | 7 & 8 | Brown |
The + side of each pair is called the "tip" and the - side is called the "ring", a reference to old telephone connectors.
| <a href="http://kiev-security.org.ua" title="Самый большой объем в сети онлайн инф-ции по безопасности на rus" target="_blank"><img src="http://kiev-security.org.ua/88x31.gif" width="88" height="31" border="0" alt="security,безопасность,библиотека"></a> |
Кнопочка будет выглядеть вот так (1,516 байт):
